EvansHQ

Home bases Madison Road

Carriage house

The carriage house, home of the Tomorrows Heirlooms shop.

It's not clear whether this was built with the original house or with the c.1910 addition. The wooden floor and sliding doors of the right side argue for the former as it would have been to house carriages. However the carriage house is not visible in the original house photo and the facade detailing closely matches that of the kitchen addition, so I suspect it was built slightly later than the main house. The second floor may have housed a servant who took care of transportation. It has two bedrooms, a bath and a large loft with sink. The entire building is heated by a small boiler in the basement under the right side.

Renovation of the carriage house was our top priority (right after the second floor laundry) because the building was home to Tomorrows Heirlooms with work in progress. The shop was completely wired and back in operation within about two weeks after our move including replacing the boiler tubes which had broken from a freeze. Painting and fabricating a new ionic pilaster capital for above the north front dormer were the only cosmetic renovations to the building. Several people have called us asking to rent a room above the carriage house and many such buildings in the neighborhood have been sold and converted to houses. It has about 3000 sq.ft. of living space.

All of the stationary woodworking equipment is located in the carriage wing with dust collection and compressed air coming from equipment in the basement below. Wood racks, and assembly workbenches are located in the garage side in front of the car bays which are deep enough to easily accommodate shop plus cars. Only at the completion of a full kitchen did we have to leave cars out of the garage. Water and gas come from the main house, but electricity comes in from a separate transformer and meter. We added an auxiliary ceiling mounted gas furnace for rapid heat recovery when the door was opened.

Carriage House today
Carriage House today
Missing Ionic Capital
Missing Ionic Capital
Garage before shop
Garage before shop
Carriage side before shop
Carriage side before shop
Loft today
Loft today
Stationary equip side
Stationary equip side
Stationary equip side
Stationary equip side
Assembly Side
Assembly Side
Saw/Shaper dust collector
Saw/Shaper dust collector

Stationary equipment

Delta Unisaw with Biesmeyer T square fence 230v. 3HP
Delta EHD Speedmatic router #5362 under saw wing table 110v. 23,000rpm
Delta 12" Gap Lathe and Vega duplicator 110v. 2HP
Delta 2 speed Shaper and power feeder 230v. 2 HP
Hitachi 10" chop saw with FlipStop fence 110v.
Delta 13" planer Model rc-33 230v. 2HP
Delta 8" longbed joiner DJ-20 230v. 2HP
Delta 15" drillpress 110v. .5HP
Delta sawbuck compound miter saw 110v.
Hitachi 3"Resaw/bandsaw with carter guides B600A 110v. 2.5HP
Mini-max 8' stroke sander with power table L55 230v. 3HP
Delta grinder/polisher 110v. .5HP
Delta stationary Plate Joiner Model 32-100 110v.
Delta 6" belt sander AFM-6 230 v. 2HP
Delta dust collection (2) 230v. 2HP
Desco 5 HP compressor for sanders 230v. 5HP
SSC Panel Saw 110v. 2.5HP
Inflatable drum sander 110v. 1HP